Handmade from copper, brass, and stainless steel to offer a well-balanced and substantial writing experience. As expressive as the ideas it creates, the Brush Fountain Pen is available in Fine and Medium point nibs
Features
Full copper body
Intricately engraved brass grip
Brass nut on cap
Total length: 143mm
Cap length: 57mm
Grip length: 24mm
Total weight: 23g
Nib: Stainless Steel Medium Point OR Fine Point
Length: 17mm
Width 7mm
Filling System: standard Universal sized piston converter with a ~0.75ml chamber
Care Instructions
DO NOT post the cap onto the back of the pen when writing. Our pen has been designed and balanced to write with the cap un-posted. Don't worry, the nut shaped cap will prevent it from rolling away
The threads of the cap are brass so they can damage the finish of the paint if you post the cap
Store pen vertically with the tip pointing upwards when not in use to minimize clogging
The brass is designed to patina and age gracefully over time, and consistent use will ensure the finish stays brilliant. However, you can also use standard brass cleaner to restore the finish.
Filling your Brush Fountain Pen
Unwind the grip from the barrel of the pen to reveal the converter
Pull the converter off of the grip assembly
Clean your nib and converter by rinsing it in cold water until water runs clear
If the pen has not been in use for a few weeks, you may need to submerge the nib for an hour to loosen up the ink
Air dry the nib and converter and reassemble when fully dry
Twist the end knob until the piston is fully depressed
Submerge the entire nib into the ink, and SLOWLY twist the piston to draw the ink until the converter is fully extended
It is normal to have some small air pockets at the top of the converter.
